Thibra3D SKULPT - Original

Unique features

• Sculptable by applying heat

• • Use a heat gun to project a temperature of ± 70°C to the part of the SKULPT 3D printed object which requires finetuning by sculpting and/or remodeling

  • Easily smooth out visible 3D printed layers and imperfections caused by blobs, zits and removed support structures

• Very easy to paint with acrylic paints

• • SKULPT 3D printed object only has to be degreased with soap and lukewarm water before painting

• SKULPT 3D printed objects can be polished

• Repeatedly sculptable and reusable

• • SKULPT 3D printed objects can continuously sculpted by remodeling, carving, cutting, adding extra material SKULPT material, etc…

  • Leftover support structures can be reused for sculpting

  • Does not dry out or crack

• Self-supporting

• • 3D print support structures with the same SKULPT 3D printer filament as used for the primary objects as the object can perfectly be smoothed out and leftover support material can be reused for sculpting

General printing guidelines *

*) Above displayed settings are meant as guidance to find your optimal print settings. These ranges in settings should work for most printers, but please do feel free to experiment outside these ranges if you think it is suitable for your printer. There are a lot of different type of printers, hot-ends and printer offsets that it is extremely difficult to give an overall one-size-fits-all setting.

*) For printers that use a 2.85mm SKULPT 3D printer filament the recommended printing (nozzle) temperature range is ± 200 - 220° C (benchmarked on Ultimaker 2. For printers that use a 1.75mm SKULPT 3D printer filament the recommended printing (nozzle) temperature range is ± 190 - 210° C (benchmarked on Prusa I3 MK2).

*) The heated bed should be set at 60° C for 3D printing the first layer of your SKULPT 3D printed object and then lowered 45° C for 3D printing the remainder of your SKULPT 3D printed object .

*) When 3D printing with SKULPT 3D printer filament on a 3D printer that uses 2.85mm SKULPT filament it is recommended to increase the flow rate to ± 121% (benchmarked on Ultimaker 2). When 3D printing with SKULPT 3D printer filament on a 3D printer that uses 1.75mm SKULPT filament it is recommended to increase the flow rate to ± 110% (benchmarked on Prusa I3 MK2).

Filament length

Product export information

Compliance *

This filament is compliant to below listed directives and regulations.

• RoHS directive 2011/65/EC

• REACH directive 1907/2006/EC

*) This declaration of conformity to directives and regulations is prepared according to our present standard of knowledge and may be amended if new cognitions are available and applies only for the above described products.